2025-2026 Chevrolet Equinox Auto Start Stop Eliminator | Plug & Play

Built for the 2025–2026 Chevrolet Equinox, this plug-and-play memory harness keeps Auto Stop/Start in whatever state you left it. Press the button once, and the setting carries over to the next start. It plugs in line with the factory connector named in the instructions, using factory-style plugs on both ends, so nothing is cut or spliced.

Nothing is reprogrammed in the engine computer. The module only stands in for the button press you would otherwise make after every start, and it comes out without leaving a trace.

Fitment

The fitment table for this SKU lists the following, each marked as a 100% fitment match:

• Chevrolet Equinox: 2025–2026

For reference, the Chevrolet Equinox in these years is a compact crossover offered with 1.5L turbo four-cylinder engines, with a 2.0L turbo four-cylinder offered on earlier model years. The table does not separate trims; what matters is that the vehicle has factory stop-start and the connector shown in the photos.

How Auto Stop/Start behaves from the factory

With Auto Stop/Start active, the engine shuts off when the vehicle comes to a stop and restarts when you lift off the brake or press the accelerator. The off button is a manual override for that drive only. Turn the ignition off and back on, and the system defaults to on again, so drivers who prefer it off end up pressing the button at the start of every trip.

Before blaming the module

A dead or weak battery, a charging problem or an unrelated module fault will change how Auto Stop/Start behaves with or without this part installed. Scan the vehicle for stored codes, test the battery and confirm the system works normally with the factory button before installation. That baseline makes any later issue easy to pin down.

Keep the battery healthy

If the stop-start indicator shows the system as unavailable, test the battery before anything else. On stop-start vehicles that is the most common cause. A replacement should match the original specification (AGM or EFB), and some manufacturers call for a battery monitor reset after the swap.

Why owners turn it off

Drivers usually switch stop-start off for comfort or habit. A restart at every stop is noticeable in a compact crossover, the climate system may run at reduced output while the engine is off, and quick moves into traffic feel slower when the engine has to fire first. If those are your reasons, you probably press the button on every drive now. With the module, you press it once.

Connecting it

It plugs in line with the factory connector named in the instructions, using factory-style plugs on both ends, so nothing is cut or spliced. Because it is plug-in only, removal is the reverse: unplug the module and reconnect the factory connectors directly. Keep the original clips and trim fasteners if you remove a panel to reach the connector.

Scope of the module

• Does not disable warning lights or diagnostic functions.
• Fuel use changes only the way it would if you pressed the off button yourself.
• Carries your stop-start choice over to the next drive.
• Comes out in the same way it went in, with nothing cut.

If stop-start is not engaging

Auto stop needs several conditions at once: a warm engine, enough battery charge, moderate cabin heating or cooling demand, and the vehicle fully stopped with the brake held. If any is missing, the engine keeps running. The module only remembers the button state; the factory controller still decides whether a stop is allowed.

Quick fitment check

• Model year and model match a row in the table above (2025–2026 Chevrolet Equinox).
• Your Chevrolet Equinox has the factory stop-start button. Base trims or engines without stop-start have nothing for the module to remember.
• The battery and charging system test good and no warning lights are on.
• The connector at your install point matches the one in the product photos.
• No aftermarket remote start, alarm or gateway bypass is wired into the same circuit. If one is, email support before ordering.
• If you are unsure, send your VIN to support@automotivebypass.com and we will confirm fitment.

Ordering details

We ship free within the contiguous United States (1–2 business days to dispatch, roughly 3–4 business days in transit). If it turns out to be the wrong part, request a return authorization within 45 days; returns carry a 20% restocking fee and return postage is on the buyer. Coverage is a 3-year limited warranty. Questions go to support@automotivebypass.com, weekdays 9 a.m. to 5 p.m. PST.