Chevrolet Silverado 3500 / 3500 Classic / 3500 HD 2007-2016 TPMS Sensor Emulator

This module is for the 2007 Chevrolet Silverado 3500 Classic, 2008–2016 Chevrolet Silverado 3500 HD and 2008–2013, 2015–2016 Chevrolet Silverado 3500. It emulates the factory TPMS sensors, so a set of wheels without sensors does not trigger the low-tire or system-fault warning on the dash. It does not measure air pressure. Once it is in use, checking pressures with a gauge is your job, not the dashboard's.

Covered applications

Each row below is listed as a 100% fitment match:

• Chevrolet Silverado 3500 Classic: 2007
• Chevrolet Silverado 3500 HD: 2008–2016
• Chevrolet Silverado 3500: 2008–2013, 2015–2016

Use the model and year rows above as the deciding check. Different receivers or sensor configurations within the same nameplate are why fitment is listed this narrowly.

The factory TPMS in brief

Every wheel on the Chevrolet normally carries a pressure sensor with its own ID, and the vehicle only listens for the IDs it has learned. Mount wheels without sensors and those IDs stop transmitting, so the system reports a fault. Under FMVSS No. 138, that fault shows as a TPMS light that flashes for roughly a minute at start-up and then stays lit, repeating on every start until the system sees its sensors again.

Safety and legal notes

TPMS is required safety equipment on new light vehicles in the US under FMVSS No. 138, and 49 U.S.C. 30122 prohibits manufacturers, dealers and repair businesses from knowingly making such equipment inoperative. Requirements for owners and for state inspections vary. Whatever the use, a tire gauge and regular visual checks replace the warning the system would have given you.

Using the placard pressure

Without TPMS warnings, a monthly routine does the job: tires cold, gauge on each valve, compare with the door-jamb placard, top up as needed, and look over the tread and sidewalls. Larger off-road or winter tires may call for different pressures than the factory placard; follow the tire maker's guidance in that case.

When the original wheels go back on

When you go back to the original sensor-equipped wheels, remove or disconnect the emulator as the instructions describe and let the vehicle recognize its sensors again. If the original sensors were rotated or replaced, the vehicle may need its normal TPMS relearn. Store the sensor wheels indoors and keep the valve caps on to keep moisture out of the valve stems.

If the warning stays on

Before installation, make sure the TPMS system works on the original wheels. If it already shows a fault with good sensors fitted, the problem is in the vehicle (receiver, module or wiring), and that needs repair first. Starting from a working system makes the emulator setup straightforward to check.

Typical uses

Most buyers have wheels without sensors that they use part of the year, such as a winter set, a track set or a show set. The emulator keeps the dash clear while those wheels are on. When the original sensor-equipped wheels go back on, the factory system can be returned to normal operation following the instructions.

What it does and does not do

• Supplies the TPMS signals the listed vehicle expects so the warning stays off on wheels without sensors.
• Does not read, store or display real tire pressures.
• Does not repair a faulty receiver, body module or wiring.
• Does not replace pressure checks with a gauge or tire inspections.

Fitment check

• Your model and year match a row above (2007 Chevrolet Silverado 3500 Classic, 2008–2016 Chevrolet Silverado 3500 HD and 2008–2013, 2015–2016 Chevrolet Silverado 3500).
• The TPMS system works normally on your original sensor-equipped wheels.
• No aftermarket TPMS receiver or display has been added.
• You have a tire gauge and will check pressures manually.
• Unsure? Email your VIN to support@automotivebypass.com.

Warranty and returns

We ship free within the contiguous United States (1–2 business days to dispatch, roughly 3–4 business days in transit). If it turns out to be the wrong part, request a return authorization within 45 days; returns carry a 20% restocking fee and return postage is on the buyer. Coverage is a 3-year limited warranty. Questions go to support@automotivebypass.com, weekdays 9 a.m. to 5 p.m. PST.